Doorways and walking paths
Measure the narrowest clear opening and the usable path after accounting for door frames, handles, furniture and equipment.
Use this guide to prepare preliminary measurements for doorways, walking paths, bedrooms, stairs, furniture layout and home-access support. It can be used for children or adults.
You do not need to complete every field. Enter “Not sure” or “Unable to measure safely” where appropriate.
These measurements support SafetyAid’s equipment and accessibility review but do not confirm structural suitability, installation safety or complete fall-risk control.
Do not climb on unstable furniture, use an unsafe ladder, move heavy furniture alone or enter an area where there is a fall, electrical or structural risk.
Measure only clear and safely accessible spaces. Stop if the person, caregiver or person taking measurements may become unstable or injured. Record “Unable to measure safely” when necessary.
Measure the narrowest clear opening and the usable path after accounting for door frames, handles, furniture and equipment.
Measure the bed height and clear space on the side normally used for transfers or caregiver assistance. Do not move or transfer the person merely to take measurements.
Record the number, approximate height and location of steps or thresholds only when they can be observed safely. Do not climb or lean over stairs to measure.
Record doorway restrictions, turning space, furniture position and obstacles affecting access.
Note existing rails, furniture supports or possible support locations. Do not drill, install or load-test any support based only on this preliminary guide.
Leave the value blank or record “Unable to measure safely.” SafetyAid may request a photo, video, professional observation or later measurement.
A family member or caregiver may prepare preliminary home measurements. Complex access, transfer, mobility, balance, fall-risk or structural-modification needs may benefit from input from an occupational therapist, physiotherapist, accessibility specialist, rehabilitation professional or appropriately qualified building professional.
Professional involvement is helpful where needed but is not required to begin a SafetyAid assessment.
This guide supports preliminary equipment and accessibility planning only. It does not provide medical diagnosis, treatment, a complete home-safety assessment, structural approval or installation certification.
Rails, ramps, wall-mounted supports and structural modifications should be assessed and installed by appropriately qualified people.
Measurements are optional. Photos or short videos can also help SafetyAid & Co. understand the home environment.
Measurement unit: centimeters (cm). Please write all measurements in centimeters.
Enter the SafetyAid & Co. Reference ID shared with you so these measurements can be matched to your case/order.
If SafetyAid & Co. gave you a reference ID, enter it here so these measurements can be matched with the correct case or order.
Most new users will not have a SafetyAid or RehabMart reference number. Leave this blank unless SafetyAid has already provided one.
| Area to review | Measurement / answer | Notes for SafetyAid & Co. |
|---|---|---|
| Bed height | ||
| Doorway width | ||
| Walking path width | ||
| Furniture position | ||
| Bedside transfer side | ||
| Support placement needed | ||
| Fall-risk points | ||
| Caregiver assistance |
Review the entered values before printing or saving as PDF. Nothing is automatically sent to SafetyAid.
WhatsApp sharing opens a prefilled message containing the details entered on this page. Review the message before sending. Information shared through WhatsApp is subject to WhatsApp’s privacy and retention practices.
Use Print / Save as PDF if you prefer not to place the entered measurements into a WhatsApp link.
After completing the measurements, save as PDF or send them to SafetyAid & Co. through the approved contact channel.